Till startsida
Sitemap
To content Read more about how we use cookies on gu.se

The plastics industry is leaking huge amounts of microplastics

News: Feb 14, 2018


Build-up of pellets at the mouth of the Stenungeån River leading out to the Askerö fjord. Photo: Martin Hassellöv.

Millions of plastic pellets are leaking out into the environment from a manufacturing site in Stenungsund. This has been shown by a new study conducted by researchers at the University of Gothenburg. Despite several international and national sets of regulatory frameworks, the leaking continues.

The problem of plastic pellets in marine environments has been reported since the 1970s and the first recommendations for legislation were introduced in the USA back in the 1990s. However, in Sweden, these spills have only received attention in recent years.

Small plastic pellets are used as raw materials. The pellets are shipped from the manufacturing site to different plants where they are used in production of various types of plastic goods.

The pellets that leak out can be found in the whole archipelago

In the recently published study, the researchers also investigated how pellets have spread in the coastal region, and they could see that the plastic pellets end up on nearby beaches, in the fjord and the nearby archipelago.
In contrast to other plastic waste, for example, packaging material, these plastic pellets have never been of any use.

“In order to better understand how plastic pellets end up in the environment, we have documented, measured and calculated the flows of the pellets via waterways leading out from the production and distribution plants in Stenungsund where approximately five percent of the polyethene that is used in Europe is produced,” says Martin Hassellöv, Professor at the Department of Marine Sciences, University of Gothenburg.

The research team’s calculations show that continuous leakage leads to between 3 and 36 million plastic pellets spreading from the Stenungsund production site every year.

“When we analysed the smaller fractions, which are called fluff and fragment, the plastic leakage was more than a hundred times greater than when we only counted the pellets. Moreover, we have seen that there are more leakage problems in conjunction with the transport, cleaning, loading and storing of pellets further along the production chain,” says Therese Karlsson, doctoral student at the Department of Marine Sciences.

Pellets are often found in the stomach content of seabirds like fulmars, which feed from the surface of the sea.

Existing regulatory frameworks should prevent leakage

There are several international agreements, EU legislation and Swedish laws that are intended to prevent this sort of spills of plastic.

“The accountability regulations in the Swedish Environmental Code are intended to prevent the leaking of large amounts of pellets, especially in areas like the one around Orust and Tjörn where there are a number of nature reserves,” says Lena Gipperth, Professor of Environmental Law at the Department of Law.

But the study shows that the existing regulations have not been applied, and this may be the result of inadequate supervisory procedures and control programmes.

The study has been published in the scientific journal “Marine Pollution Bulletin”.

Title of the article: The unaccountability case of plastic pellet pollution
Link to article: https://doi.org/10.1016/j.marpolbul.2018.01.041

Contact:
Martin Hassellöv, Professor at the Department of Marine Sciences, University of Gothenburg
031-786 9050, 0766-22 90 50, martin.hassellov@gu.se
Photo:
Picture 1: Build-up of pellets at the mouth of the Stenungeån River leading out to the Askerö fjord. Photo: Martin Hassellöv.
Picture 2: Every year, millions of pellets leak out from the production site into the environment where animals can mistake the pellets for food. Photo: Therese Karlsson.


 

BY:

Originally published on: science.gu.se

Page Manager: Sven Toresson|Last update: 1/2/2012
Share:

The University of Gothenburg uses cookies to provide you with the best possible user experience. By continuing on this website, you approve of our use of cookies.  What are cookies?